SEISMOLOGY AND GEOLOGY ›› 2018, Vol. 40 ›› Issue (3): 611-621.DOI: 10.3969/j.issn.0253-4967.2018.03.008

Previous Articles     Next Articles

SEISMIC INTENSITY EVALUATION MODEL IN MEIZOSEISMAL AREA BASED ON FOCAL DEPTH

NIE Gao-zhong1, XU Jing-hai2   

  1. 1. Institute of Geology, China Earthquake Administration, Beijing 100029, China;
    2. College of Geomatics Engineering, Nanjing University of Technology, Nanjing 210009, China
  • Received:2017-09-11 Revised:2018-01-12 Online:2018-06-20 Published:2018-07-21

基于震源深度的极震区烈度评估模型

聂高众1, 徐敬海2   

  1. 1. 中国地震局地质研究所, 北京 100029;
    2. 南京工业大学, 测绘科学与技术学院, 南京 210009
  • 作者简介:聂高众,男,1964年生,1990年于中国科学院地质研究所获第四纪地质学专业博士学位,研究员,主要从事地震应急、地震综合减灾研究,E-mail:niegz@ies.ac.cn。
  • 基金资助:
    国家科技支撑计划项目(2012BAK15B06)资助

Abstract: China is the country with the challenge of severe earthquake disaster. In order to mitigate the disaster and save lives, emergency response and rescue work after an earthquake are deployed and led by the Chinese governments at all level, the effectiveness of which has been proved. In such work, how to quickly evaluate the seismic intensity in meizoseismal area is a crucial issue at the early period after the earthquake. It is the foundation to estimate the disaster losses and decide the scale of rescue teams and materials. However, at the early period only a few physical parameters of the earthquake can be acquired and some of them may even be inaccurate.
An evaluation model of seismic intensity in meizoseismal area is investigated and presented by statistic method in this study. After an earthquake there are four authoritative parameters officially released by China Earthquake Administration generally within ten minutes:earthquake magnitude (MS), focal depth, latitude and longitude position, and the occurrence time. They are good candidate input parameters of the evaluation model. We collect the information of 215 historical earthquake occurring in China from 1966 to 2013, including:The four parameters and the seismic intensity in meizoseismal area. Through statistical analysis we find the seismic intensity in meizoseismal area has high correlation with the earthquake magnitude (MS) and the focal depth and then select them as the formal input parameters. After further investigation a generalized linear model is built to fit the relationship between the seismic intensity in meizoseismal area, earthquake magnitude (MS) and the focal depth.
The effectiveness of the model is validated by the Sig value and F value from theoretic perspective. The validation also includes the application of the model in real earthquakes occurring from 2014 to 2017. After the earthquakes, the seismic intensities in meizoseismal area have been quickly estimated and used in the command of national earthquake disaster emergency relief. The applications in real earthquakes get good results.
Finally, the robustness of the model is analyzed. We respectively verify the influences of the earthquake magnitude (MS) and the focal depth and find the seismic intensity in meizoseismal area is more sensitive to the earthquake magnitude. Under the condition of the same focal depth, when the change of the earthquake magnitude is up to 0.5, the change of the seismic intensity will reach to 1. However, in order to cause same change of the seismic intensity, the difference of the focal depth will be 10 kilometers. Basically, these changes derived from the model meet the situation of historical earthquakes.

Key words: earthquake emergency, seismic intensity in meizoseismal area, seismic intensity evaluation model

摘要: 震后极震区烈度的准确快速评估是地震应急决策与救援的基础性工作。文中首先收集整理了1966—2013年的215条震级>5.0的历史震例,基于输入参数可在震后快速获得的原则,通过分析极震区烈度与不同地震参数的相关性关系,通过拟合方法构建了1种面向地震应急的,以中国地震局正式发布的地震震级、震源深度为输入参数的极震区烈度快速评估模型。然后从统计的角度分析了该模型拟合的有效性,同时对2个输入参数进行了敏感性分析,表明该方法可在震后快速有效地估算极震区烈度。目前该模型在实际地震应急中已得到了初步应用,并取得了良好的效果。

关键词: 地震应急, 极震区烈度, 烈度评估模型

CLC Number: